Begin by folding one end of the burlap ribbon in half, then in half again.
Attach the end of burlap ribbon to the innermost ring of the wreath frame using floral wire and push the ribbon edge counter-clockwise until it meets a vertical bar.
Pull the ribbon through the first section of the frame to form a loop, then repeat in the middle and outer sections to form three equal loops.
Once you reach the outermost ring, twist the ribbon twice counter-clockwise and "scrunch" the loops toward the vertical bar of the wreath frame. Then repeat step 3.
If you run out of ribbon, simply begin with a new roll wherever you stopped.
Once the entire wreath is full, cut any remaining ribbon off and attach the end to the wreath form as in steps 1-2.
To create a banner/bunting for your wreath, simply download the SVG (for Cricut/Cameo) or JPEG files on my website at firstdayofhome.com. Use hot glue or clips to attach it to jute twine to hang.